DP-M Series Volt Meters
Voltage and current in, multi-function digital control meter.
Features two lines displaying the current value and setting value simultaneously. Easy-to-use multiple range scaling; either manually or by using the "teach" function setup with a forced zero. It provides sensor-reserved power for use. The use-load function of the cell will be a load-cell list.
Specifications
| Supply Voltage | AC/DC 90~260V 50/60Hz |
| Consumed Power | Max. 15VA |
| Insulation Impedance | 20M£[ at least (DC500V) between connecters |
| Hi-pot test | AC2000V min between connecters and the case |
| Noise susceptibility | 2KV 5KHz |
| Ambient temperature | 0~+50°C |
| Ambient Humidity | 28~85%RH(No fog) |
| Storage temperature | -20~+65°C |
| Weight | 285g |
| External Dimensions | 96(W)X48(H)X140(L)mm |
Features
| Input signal | AC. DC Voltage current |
| Sampling Timers | 15 preset. at 60Hz, 12.5 preset at 50Hz |
| Maximum display value | -19999~99999 |
| Accuracy | 0.1%FS (DC, Voltage, current) |
| 0.2%FS (AC, Voltage, current) | |
| Display specification | 0.56" red LED, 0.3" Green LED |
| Force to zero | External setup, use, and store function |
| Ratio setup | Decimal point position can be adjusted manually, directly from the "teach" mode panel. |
| Keep function | Record the maximum value by measuring input. When power supply is on, it can be cleared manually or automatically |
| External functions | Hold measured value; clear maximum value; display maximum value and force to zero. |
| Other functions | set startup delay time; compare output; can set the delay time in each section |
| Process average value (move mode or simple mode) | |
| Comparing output has three modes to choose from.(Standard, Zone, level) | |
| Output mode | Relay contact output, transistor output, linear output, communication output. |
Distributors welcome.
